  |
|
|||
|
|||
| |
|||
|
|||||||||||
 |
|||||||||||
 |
 |
ProductsConveyor
belt systems & Service MaterialsConti
Clean A-HExamples
of use |
|||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||
|
Conti Clean A-H: Examples of use Clean - even when conveying titanium dioxide.
Belt surfaces are subjected to harsh conditions by the Dual System. With
the Conti Clean A-H conveyor belt, it was possible to significantly improve
the hygienic conditions in the manual sorting area. The glossy appearance
of the belt is impaired only by white spots resulting from the repeated
wetting of the belt surface with house paint. It was determined however
that these paint spots could be removed with little effort. One of Europe's
most modern conveyors for light packaging materials is located at Trienekens
in Krefeld. The conveyor operator Franz W. Hahn has confirmed that it
is possible to clean the Conti Clean A-H much more effectively.
Conti Clean A-H needs just a minimum cleaning impulse to obtain the desired degree of cleanliness. This is achieved with a soft blade of 45 - 50 Shore A rubber at a right angle to the edge of the belt or a cleaning brush. Without this "soft" cleaning of the belt, problems can arise. If there is no belt cleaning whatsoever, the resulting accumulations can be more or less severe, depending on the medium. If however existing "hard scrapers", such as hard metal scrapers or plastic segment scrapers, are left in the conveyor without being modified, the plastic coating can be destroyed prematurely by cuts from sharp-edged media (e.g. glass or granulated material from melting chambers). Therefore please always provide "soft" belt cleaning for Conti Clean A-H.
Conti Clean A-H has been used successfully as lining material for chutes
in the sorting of cucumbers at the Kühne company. Conti Clean A-H
lining in chutes prevents product jams due to sticking.
Belt surfaces are subjected to harsh conditions by the Dual System. With
the Conti Clean A-H conveyor belt, it was possible to significantly improve
the hygienic conditions in the manual sorting area. The glossy appearance
of the belt is impaired only by white spots resulting from the repeated
wetting of the belt surface with house paint. It was determined however
that these paint spots could be removed with little effort. One of Europe's
most modern conveyors for light packaging materials is located at Trienekens
in Krefeld. The conveyor operator Franz W. Hahn has confirmed that it
is possible to clean the Conti Clean A-H much more effectively.
Practice has shown that when a dry product is conveyed, product residue
always remains on the belt. With residual product moisture of up to approximately
20%, the belt is kept absolutely clean by a rubber blade with a Shore
A hardness of 45. In the case of greater product moisture, the belt can
be cleaned using blades with a higher Shore hardness, e.g. rubber with
60 Shore A or polyurethane with 70 Shore A.
|
||||||||||||||||||||||||||||||||
